White fuzzy mold on houseplant soil is a harmless fungus that feeds on damp potting mix. To get rid of it, scrape off the top layer of soil, let the pot dry out, and give the plant more light and moving air. The mold does not hurt the plant, but it tells you the soil is staying wet too long.
I earn a commission when you buy through links to Amazon. It costs you nothing extra.
What the mold is
Potting mix is made of peat, coir, bark, and compost. Fungi break these down. Their spores are in every bag of mix and in the air of every home. Given damp soil, still air, and low light, the fungus grows a white or pale yellow fuzz across the surface.
This kind of fungus eats dead material in the soil. It does not attack living roots or leaves. The same wet conditions that feed it can lead to root rot, though, and that does hurt the plant. Treat the mold as a warning.
Make sure it is mold
A few other things turn soil white.
| What you see | What it is | What to do |
|---|---|---|
| Soft white or yellow fuzz that smears when touched | Mold | Follow the steps below |
| Hard, dry white or tan crust on soil or the pot rim | Mineral and fertilizer salts | See white crust on houseplant soil and pots |
| Small white balls that crush to powder | Perlite | Nothing. It is part of the mix. |
| Small yellow or tan caps on stalks | Mushrooms | See why mushrooms grow in houseplant soil |
| White specks that move or jump | Springtails or soil mites | See tiny white bugs in houseplant soil |
How to remove mold from the soil
- Take the plant to a sink or outdoors. This keeps loose spores out of the room. People with mold allergies or asthma can wear a mask for this job.
- Scrape off the top layer. Use a spoon to lift off the top 2.5 cm (1 in) of soil. Put it in a bag and into the trash.
- Check below the surface. Push a finger down into the pot. Soggy soil with a sour smell points to a deeper problem. Slide the plant out and look at the roots. Firm, pale roots are fine. Brown, soft roots need the steps in what causes root rot and how to fix it.
- Let the soil dry. Wait to water until the top 2.5 to 5 cm (1 to 2 in) of soil is dry. Most leafy plants handle this well.
- Top up with fresh mix. Add a thin layer of new, dry potting mix to replace what you took out.
- Wipe the pot. Clean the rim and the outside of the pot with a damp cloth.
- Move the plant to brighter light and moving air. Mold grows slowly on a soil surface that dries between waterings.
Should you use hydrogen peroxide or cinnamon?
Diluted hydrogen peroxide kills mold on the soil surface. Mix 1 part 3% hydrogen peroxide with 4 parts water and water the soil with it once. A bottle of 3% hydrogen peroxide from Amazon or any drugstore works. Follow the label on the bottle and keep the mix off the leaves.
Peroxide is a short fix. The mold comes back if the soil stays wet.
Many people dust cinnamon on the soil. It may slow mold on the surface for a while. It does not change the damp conditions underneath, so do not count on it alone.
Why the mold grew
Mold needs three things: moisture, food, and still air. Change the conditions and it stops.
Watering too often. This is the main cause. Soil that never dries on top grows mold. Water by touch, not by the calendar.
Low light. A plant in a dim spot uses little water. The soil stays wet for weeks. This is common from November to February, when days are short.
Still air. Plants packed on a shelf or pushed into a corner get no air movement across the soil.
A pot with no drainage hole. Water pools in the bottom and the whole pot stays damp. See how to use a pot without drainage holes.
A pot that is too big. Extra soil holds extra water that the roots cannot reach.
Old or heavy soil. Mix breaks down over time. It packs tight and holds more water.
Organic matter on the surface. Dead leaves, coffee grounds, and food scraps on top of the soil feed mold. Pick them off.
How to keep mold from coming back
- Water only when the top 2.5 to 5 cm (1 to 2 in) of soil is dry. In winter this can mean every two to three weeks. See how often to water houseplants in winter.
- Empty the saucer 15 minutes after you water.
- Move the plant closer to a window or add a grow light.
- Leave space between pots. Run a small fan on low in the room for a few hours a day.
- Try bottom watering. The roots drink from below and the surface stays drier. See how to bottom water houseplants.
- Loosen the top of the soil with a fork every few weeks so it dries faster.
- Add perlite the next time you repot. Two parts potting mix to one part perlite drains faster. Perlite from Amazon comes in small bags.
- Store open bags of potting mix dry, in a bin with a lid.
Is the mold harmful to people or pets?
The mold on potting soil is a common household fungus. It does not harm the plant. Its spores can bother people who have mold allergies or asthma. If someone in the home reacts to mold, remove it right away and keep the soil surface dry. Keep pets from digging in or eating moldy soil.
When to repot instead
Scraping the surface is enough for most pots. Repot the plant in fresh mix when:
- The mold returns within a week or two of each cleanup.
- The soil smells sour or swampy.
- The soil stays wet for more than two weeks after a watering.
- The roots are brown and soft.
- Fungus gnats are flying around the pot as well.
Shake off as much old soil as you can. Wash the pot with hot, soapy water. Use fresh mix and a pot with a drainage hole. The steps are in how to repot a houseplant.