Perfectly Normal Plant Lady

Articles · Decorating with plants

How to mount a wall planter for indoor plants

Published 2026-11-15

To mount a wall planter, weigh it with a watered plant inside, then fasten it to a wall stud with wood screws. Where no stud lines up, use hollow-wall anchors rated by their maker for more than that weight. Protect the wall from water, and place the planter where the plant gets enough light.

Three things make a wall planter fail: more weight than expected, fasteners in bare drywall, and water getting into the wall. You can prevent all three.

I earn a commission when you buy through links to Amazon. It costs you nothing extra.

Step 1: work out the load

Weigh the planter at its heaviest, not as it comes out of the box.

  1. Pot the plant in the planter, or set its nursery pot inside.
  2. Water it fully and let it drain.
  3. Weigh it on a kitchen or bathroom scale.

Water is heavy. One liter weighs 1 kg (a US quart weighs about 2 lb), and potting mix holds a lot of it.

Then add a margin. The plant will grow, and someone will bump it or pull on a vine.

Pick fasteners and brackets rated well above the wet weight. Never match the rating exactly.

Step 2: understand how a wall planter pulls on the wall

A flat picture hangs close to the wall. Its weight pushes straight down along the wall, across the fastener. Engineers call that shear, and screws and anchors handle it well.

A planter is different. Its weight sits out in front of the wall. That makes it act as a lever. The bottom of the planter pushes into the wall, and the top fastener gets pulled outward, away from the wall. The farther the pot sticks out, the stronger that pull.

What this means for you:

  • Deep planters and brackets with a long arm need stronger fastening than flat pocket planters of the same weight.
  • The top fastener does the hard work. Put it in a stud if only one can be.
  • Check the rating that matches the pull. Some anchor makers list separate ratings for shear and for pull-out, also called tension. Pull-out ratings are lower. A planter that sticks out loads the anchor both ways.

Step 3: find the studs

Most North American interior walls are drywall over wood studs. The studs are the structure. They are usually spaced 40 cm (16 in) apart, center to center, and sometimes 60 cm (24 in).

  • Slide an electronic stud finder across the wall and mark both edges of the stud. The center is halfway between.
  • Check it another way. A strong magnet finds the drywall screws along a stud. A knock sounds dull over a stud and hollow between them.
  • Drill a small pilot hole. Solid wood behind the drywall means you found it.

A stud finder from Amazon with wire detection is worth having for this job.

Before you drill

Wires usually run straight up and down from outlets and switches. Pipes run behind kitchen and bathroom walls. Do not drill directly above, below, or beside an outlet or switch. Drill only as deep as you need.

Step 4: choose the fastener

Wall Best fastener Notes
Drywall over a wood stud Wood screws into the stud The strongest choice. Use screws long enough to pass through the drywall and bite deep into the wood.
Drywall, no stud Toggle bolts or other metal hollow-wall anchors The drywall itself is the limit. Keep to light planters and follow the maker’s rating.
Brick or concrete Masonry anchors with a hammer drill Use anchors rated for the load. Drill into the brick or block the anchor maker specifies.

Rules that apply to every wall:

  • Use the maker’s rating. The package or listing gives a working load. If it gives none, do not trust it with a planter.
  • Use the fasteners that come with the planter only if they suit your wall. Many kits include small plastic plugs. Replace them for anything heavy or deep.
  • Skip adhesive strips and adhesive hooks for pots with soil.
  • Spread the load. Two or more fasteners are better than one. A board screwed into two studs lets you hang planters anywhere along it.
  • Check every part. The bracket, the ring, the hook on the pot, and the pot itself all have limits. The weakest part governs.

For walls without a stud in the right place, search for toggle bolt drywall anchors and read the load rating on the listing and the package.

Step 5: mount it

  1. Pick the height. Hang the planter where you can see the soil and reach it.
  2. Mark the holes. Hold the planter or its bracket against the wall. Use a level. Mark each hole with a pencil.
  3. Drill pilot holes. For a stud, use a bit a little narrower than the screw’s solid core. For anchors, use the bit size the anchor maker lists.
  4. Set the anchors, if you are using them, as the package directs.
  5. Drive the screws. Stop when the bracket is snug and flat to the wall. Overdriving strips wood and crushes drywall.
  6. Test it empty. Pull down and outward on the planter with your hands, harder than the plant will.
  7. Load it and watch. Add the plant. Check the top fastener after a day and again after a week.

A gap opening at the top of the bracket or a screw that turns freely means the fastening is failing. Take the planter down and remount it into a stud.

Step 6: keep water off the wall

Drywall is paper and gypsum. It stains, softens, and grows mold when it gets wet again and again.

  • Use a planter with no hole and an inner pot. Keep the plant in a plastic nursery pot with drainage. Lift it out, water it at the sink, let it drain fully, and put it back. This is the safest method.
  • Leave an air gap. Small bumpers or spacers behind the planter let air move so the wall behind it dries.
  • Wipe drips right away.

Step 7: choose the wall and the plant

A wall beside a window gets far less light than the windowsill. Pick a wall that faces a window or sits right beside one, and choose plants that accept medium light.

Plant Why it suits a wall planter Pet safe
Pothos Trails, tolerates medium light No
Heartleaf philodendron Trails, tolerates medium light No
Hoya Light root ball, likes to dry out Yes
Spider plant Arching leaves and hanging babies Yes
Staghorn fern Grows mounted on a board with no pot Yes
Air plant No soil at all, almost no weight Yes

Pothos and philodendron are toxic to cats and dogs if chewed. A wall planter helps keep them out of reach, as long as the vines are trimmed.

Small pots dry out fast. Check wall plants more often than floor plants.

For renters

Check your lease before you drill. If holes are not allowed, use a freestanding ladder shelf or a tiered stand. See how to choose a plant shelf that holds the weight and how to display houseplants in a small home.

Checks to repeat

  • Top fastener still tight, with no gap at the wall
  • No stains, bubbling paint, or soft spots on the wall behind or below
  • Planter reweighed after repotting or a year of growth

If the load is large or the wall is unusual, ask a carpenter or handyman. For plants hung from above, see how to hang indoor plants from the ceiling safely.

Ready when you are

Say hello