Mix perlite into potting soil to add air and help water drain. For most leafy houseplants, use 1 part perlite to 2 parts potting mix. For succulents and cacti, use equal parts. Perlite holds no nutrients, so it never replaces soil or fertilizer.
Dampen perlite before you scoop it. The dry dust is not good to breathe.
I earn a commission when you buy through links to Amazon. It costs you nothing extra.
What perlite is
Perlite is a volcanic glass. It is mined, crushed, and heated until it pops and puffs up. The result is a white, light, hard grain full of tiny air pockets.
It is the white specks in bagged potting mix. It is not foam, and it does not break down in the pot.
What perlite does:
- Makes gaps in the soil that hold air
- Lets extra water drain away faster
- Keeps soil from packing down
- Makes a pot lighter
What perlite does not do:
- Feed the plant
- Hold much water inside the grain
- Change the soil from acid to alkaline in any real way
Why houseplants need it
Roots need air as much as they need water. In a pot, soil stays wet far longer than it does in the ground. Indoors, with less light and no wind, it stays wet longer still.
Soil that stays wet has no air. Roots in airless soil die and rot. Perlite keeps air in the mix after each watering. That is the main way to prevent the problem described in what causes root rot in houseplants and how to fix it.
How much to use
Measure by volume. A part can be a cup, a tub, or a bucket.
| Plant type | Potting mix | Perlite | Other |
|---|---|---|---|
| Most leafy houseplants | 2 parts | 1 part | None |
| Aroids with thick roots | 2 parts | 1 part | 1 part orchid bark |
| Succulents and cacti | 1 part | 1 part | Some coarse sand or grit |
| Ferns and thirsty plants | 3 parts | 1 part | None |
| Rooting cuttings | None | All perlite, or half perlite and half mix | None |
Use the leafy mix for pothos, spider plant, and peperomia. Use the aroid mix for monstera and philodendron. More recipes are in best potting soil for indoor plants.
Add more perlite if any of these fit:
- The pot is large or deep
- The room is dim
- The plant is in plastic or glazed ceramic
- You tend to water often
- It is a cold-climate winter and soil dries slowly
Add less if the plant dries out too fast, or if it sits in terracotta in a hot window.
How to mix it
- Work outside or over a sink, with a window open.
- Open the bag and pour a little water in. Shake the bag gently. Damp perlite makes no dust.
- Wear a dust mask if you handle a large amount of dry perlite.
- Scoop potting mix into a tub or bucket.
- Add the perlite.
- Mix with your hands or a trowel until the white grains are spread evenly.
- Dampen the whole mix a little before you pot. It should feel like a wrung-out sponge.
Store leftover perlite in its bag, closed, in a dry place. It does not go bad.
Which grade to buy
Perlite comes in fine, medium, and coarse grades.
- Fine is for seed starting. It packs too tightly for most pots.
- Medium is the standard grade in bagged mixes. It suits small and medium pots.
- Coarse has grains about 3 to 6 mm (1/8 to 1/4 in). It makes bigger air gaps and suits aroids, large pots, and succulents.
Look for a bag labeled horticultural perlite with no added fertilizer. Some brands add fertilizer to the grains, and that makes it hard to control feeding. You can order coarse horticultural perlite from Amazon in small or large bags.
Rooting cuttings in perlite
Damp perlite holds air and moisture around a cut stem, and that helps roots form without rot.
- Fill a clear cup with perlite. Poke a few holes in the bottom.
- Rinse the perlite with water and let it drain.
- Push the cutting in so one or two nodes are covered.
- Set the cup in a shallow dish of water, about 1 cm (1/2 in) deep.
- Keep it in bright light out of direct sun.
- Pot the cutting in soil when the roots are 3 to 5 cm (1 to 2 in) long.
See how to propagate houseplants from cuttings for which plants root this way.
Perlite compared with other add-ins
| Add-in | Drainage | Holds water | Weight | Good to know |
|---|---|---|---|---|
| Perlite | High | Low | Lightest | Floats to the top over time |
| Pumice | High | Low to medium | Heavy | Stays mixed in, costs more |
| Vermiculite | Low | High | Light | Keeps soil moist, not for succulents |
| Orchid bark | High | Low | Light | Breaks down in a few years |
| Coarse sand | Medium | Low | Heaviest | Fine sand makes drainage worse |
| LECA | High | Medium | Medium | Used alone for growing without soil |
Perlite and vermiculite get mixed up, and they do opposite jobs. Perlite dries a mix out. Vermiculite keeps it wet.
Pumice is a good swap for tall, top-heavy plants because its weight steadies the pot. You can find horticultural pumice from Amazon if garden centers near you do not stock it. For clay pebbles, see how to use LECA for houseplants.
Common problems with perlite
It floats to the top
Perlite is lighter than water. Over months of watering, some grains rise and collect on the surface. It looks odd and does no harm. Water more slowly, or bottom water. If it bothers you, cover the soil with a thin layer of bark.
White specks that look like bugs or mold
Perlite grains are hard and do not move. Pinch one. It crushes to a gritty powder. Mold is soft and fuzzy. Bugs move. If the specks move, read tiny white bugs in houseplant soil and what they are.
Brown tips on sensitive plants
Perlite holds a small amount of fluoride. A few plants react to fluoride with brown leaf tips, including dracaena, spider plant, and ti plant. Rinsing perlite well before use washes some of it out. Pumice is a swap for those plants.
The mix dries too fast
Too much perlite in a small terracotta pot can dry out in a day or two. Repot with a lower share, or move to a plastic pot.
Do not layer it in the bottom
A layer of perlite or gravel in the bottom of a pot does not improve drainage. Water stays in the soil above the layer. Mix perlite through all of the soil. A drainage hole does the rest.
Quick checklist
- Dampen perlite before you handle it.
- 2 parts mix to 1 part perlite for most plants.
- Equal parts for succulents and cacti.
- Coarse grade for big pots and thick roots.
- Mix it through, never layer it.
- Keep feeding the plant, since perlite adds no nutrients.