Perfectly Normal Plant Lady

Articles · Plant care basics

Which houseplants root in water and how to do it

Published 2026-11-15

Most vining houseplants root in water, including pothos, heartleaf philodendron, monstera, syngonium, and tradescantia. Cut a piece of stem just below a node, put the node under water, and set the jar in bright, indirect light. Change the water once a week and pot the cutting when the roots are 2.5 to 5 cm (1 to 2 in) long.

Succulents, cacti, ferns, palms, and calathea do not root this way. They need other methods.

What a node is and why it matters

A node is the small bump or joint on a stem where a leaf attaches. New roots grow from nodes. On vines such as pothos and monstera, you can often see a brown nub at the node. That nub is an aerial root, and it grows fast in water.

A leaf with only its stalk and no piece of stem may grow roots on some plants, but it will never grow a new vine. Always include at least one node. The main exceptions are plants that grow from leaf cuttings, such as African violet, snake plant, and ZZ plant.

Houseplants that root in water

Plant What to cut Time to first roots Pet safe
Pothos Stem with 1 to 3 nodes 1 to 3 weeks No
Heartleaf philodendron Stem with 1 to 3 nodes 1 to 3 weeks No
Monstera Stem with a node and aerial root 2 to 4 weeks No
Syngonium Stem with 1 to 2 nodes 1 to 3 weeks No
Tradescantia Stem tip, 10 cm (4 in) About 1 week No
Spider plant A baby plant from a runner 1 to 2 weeks Yes
Swedish ivy Stem tip, 10 cm (4 in) 1 to 2 weeks Yes
Begonia Stem with 2 nodes 2 to 4 weeks No
Hoya Stem with 2 nodes 3 to 6 weeks Yes
African violet One leaf with its stalk 3 to 6 weeks Yes
ZZ plant A whole stem or a single leaf 1 to 3 months or longer No
Snake plant A leaf cut into sections 1 to 2 months or longer No

The times are rough guides. Cuttings root faster in warm rooms with long days and slower in winter. Plants marked “No” are toxic to cats and dogs if chewed, so keep jars where pets cannot reach them.

Pothos

Pothos (Epipremnum aureum) is the easiest plant to start with. Each node already has a root nub. For more detail, see how to propagate pothos in water or soil.

Heartleaf philodendron

Heartleaf philodendron (Philodendron hederaceum) roots as fast as pothos. Cut just below a node and strip the lowest leaf.

Monstera

Monstera (Monstera deliciosa) needs a piece of the main stem with a node. A leaf and stalk alone will not grow. Use a tall, heavy jar so the large leaf does not tip it.

Syngonium

Syngonium (Syngonium podophyllum) roots from every node. Older, vining stems give the best cuttings.

Tradescantia

Tradescantia (Tradescantia zebrina) can show roots within days. Root several tips and plant them together for a full pot.

Spider plant

A spider plant (Chlorophytum comosum) makes baby plants on long runners. Snip a baby off and set its base in shallow water. Keep the leaves dry.

Swedish ivy

Swedish ivy (Plectranthus verticillatus) has soft stems that root from tip cuttings. Pinch the new plant often to keep it bushy.

Begonia

Cane and angel wing types of begonia root from stem cuttings. Change the water often, since soft begonia stems rot in stale water.

Hoya

Hoya (Hoya carnosa) roots in water, but it is slow. Keep it warm and be patient.

African violet

An African violet leaf roots from the cut end of its stalk. Cover a small jar with plastic wrap, poke a hole, and slide the stalk through so the leaf blade stays dry. Tiny plantlets form at the base after the roots.

ZZ plant

A ZZ plant (Zamioculcas zamiifolia) stem grows a small round rhizome first and roots second. This takes months. Nothing is wrong if the cutting stays green.

Snake plant

A snake plant leaf roots from the bottom edge of each section. Keep the sections the right way up. Yellow-edged types usually grow back plain green from leaf cuttings. See how to propagate a snake plant.

How to root a cutting in water

  1. Pick a healthy stem. Choose growth with firm leaves and no pests.
  2. Clean your scissors. Wipe the blades with 70% isopropyl alcohol.
  3. Cut below a node. Make the cut about 1 cm (0.5 in) below the node. A cutting 10 to 15 cm (4 to 6 in) long with two to four leaves is a good size.
  4. Strip the lower leaves. No leaf may sit under water. Wet leaves rot and foul the jar.
  5. Fill a clean jar. Use room-temperature tap water. Cover the node and leave the leaves above the rim.
  6. Set it in bright, indirect light. A spot near an east or north window works. Direct sun heats the water and grows algae.
  7. Change the water weekly. Rinse the jar and the stem at the same time. Top up between changes so the node never dries.
  8. Wait for roots. Pot the cutting when the roots are 2.5 to 5 cm (1 to 2 in) long and have started to branch.

Moving the cutting to soil

Roots that grow in water are thin and brittle. They have to adjust to soil, so do not wait too long. Long water roots have a harder time.

  1. Fill a small pot, about 10 cm (4 in) wide, with damp indoor potting mix.
  2. Make a hole with a finger. Lower the roots in and firm the mix around them.
  3. Water well and let it drain.
  4. Keep the mix evenly damp for the first two weeks. Then let the top 2.5 cm (1 in) dry between waterings.

A little wilting in the first week is normal. Plant three or more cuttings in one pot for a fuller plant. If you would like to skip soil, some plants live in water for years. See indoor plants that grow in water.

Plants that do not root in water

  • Succulents and cacti. Their cuttings rot when wet. Let them dry and root them on dry mix. See how to propagate succulents from leaves.
  • Calathea, prayer plant relatives, and ferns. These grow from the base and have no stem nodes to cut. Divide them at repotting time.
  • Palms. A palm has one growing point per stem. A cut stem does not root.
  • Fiddle leaf fig and rubber plant. Stem cuttings can root in water, but they are slow and often rot. Air layering is more reliable for woody plants.

When a cutting fails

  • The stem turns brown and mushy. That is rot. Cut back to firm, green tissue above the next node, wash the jar, and start again with fresh water.
  • The water turns cloudy or smells. Change it more often and remove any leaf below the water line.
  • Nothing happens for weeks. Check that a node is under water. Move the jar to a warmer, brighter spot. Cuttings taken in winter by a cold window can sit for a long time. A spot at 18 to 24°C (65 to 75°F) is best.
  • Leaves turn yellow. One old leaf yellowing is normal. If all of them yellow, the cutting has run out of stored energy. Take a new one with a healthy node.

Take two or three cuttings each time. If one fails, you still have another. For soil rooting and other methods, read how to propagate houseplants from cuttings.

Ready when you are

Say hello