To use coco coir, soak the dry brick in warm water until it swells, break it up, and mix it with perlite and bark to make a potting mix. Coir takes the place of peat moss. It holds water well and wets again quickly after drying, but it has almost no nutrients, so plants in it need regular fertilizer.
Coir is not a complete potting soil by itself. It is one ingredient. Used alone, it stays too wet for most houseplants.
I earn a commission when you buy through links to Amazon. It costs you nothing extra.
What coco coir is
Coco coir is the fiber from the husk of a coconut. It is a byproduct of the coconut industry. The husks are soaked, shredded, dried, and pressed into bricks or bagged loose.
It comes in three forms:
- Coco peat or pith. Fine, soil-like particles. This holds the most water and is the usual peat substitute.
- Coco fiber. Long, stringy strands. This adds air and is used to line hanging baskets.
- Coco chips or husk chips. Chunks like small bark pieces. These add air and drainage, and they suit orchids and aroids.
Most bricks sold for houseplants are coco peat, sometimes with a little fiber mixed in.
Coir compared with peat moss
| Coco coir | Peat moss | |
|---|---|---|
| Source | Coconut husk, a renewable byproduct | Peat bogs, which form slowly over thousands of years |
| Water holding | High | High |
| Re-wetting after drying | Quick | Slow. Dry peat repels water |
| pH | Near neutral to slightly acidic | Acidic. Lime is added to most mixes |
| Nutrients | Almost none | Almost none |
| Breaks down | Slowly | Faster |
| Salt | Can be high if not washed | Low |
The biggest practical gain is re-wetting. A peat mix that dries out fully shrinks from the pot wall, and water runs straight past it. Coir takes water back up without a long soak.
How to hydrate a coir brick
Coir bricks are pressed hard and dry. One small brick of 650 g (1.4 lb) swells to about 8 to 9 L (2 gal) of loose coir.
- Put the brick in a bucket or tub that is much larger than the brick.
- Pour warm water over it. Use about 4 L (1 gal) for a 650 g (1.4 lb) brick, or the amount on the label.
- Wait 15 to 30 minutes. The brick swells and softens.
- Break it apart with your hands or a trowel. Add a little more water to any dry lumps.
- Fluff it until it is even, loose, and damp like a wrung-out sponge.
To use only part of a brick, cut or saw off a piece while it is dry. Store the rest dry.
Rinse it if the label does not say washed
Coconuts often grow near the sea, and husks may be soaked in salty water during processing. Low-grade coir can carry enough salt to brown leaf tips.
Look for “washed,” “low EC,” or “buffered” on the label. If it says none of these, rinse the coir yourself.
- After hydrating, fill the bucket with fresh water and stir.
- Pour the coir into a colander or an old pillowcase and let it drain.
- Repeat two or three times.
“Buffered” coir has also been treated with calcium and magnesium. Raw coir holds on to calcium and magnesium from fertilizer and gives up potassium and sodium in return. Buffering fills those spots ahead of time, so your plant gets the calcium and magnesium you feed it.
A washed and buffered coco coir brick from Amazon saves the rinsing step.
Mixes to make with coir
Measure by volume. A “part” can be a cup or a bucket.
Everyday mix for leafy houseplants
- 2 parts coco coir
- 1 part perlite
- 1 part fine bark or coco chips
This suits pothos, spider plant, peace lily, and dracaena.
Chunky mix for aroids
- 1 part coco coir
- 1 part perlite or pumice
- 1 part orchid bark or coco chips
This suits monstera, philodendron, anthurium, and hoya. Their thick roots need a lot of air.
Moisture-holding mix for ferns and calathea
- 3 parts coco coir
- 1 part perlite
- 1 part worm castings
This suits ferns, calathea, and nerve plant. See how to use worm castings for houseplants.
Gritty mix for succulents and cacti
- 1 part coco coir
- 2 parts pumice, perlite, or coarse sand
Coir is only a small share here. Succulents need a mix that dries in a few days.
Coir and perlite are the base of all four. Add orchid bark for the chunky mixes. For more on the white bits, read how to use perlite for houseplants.
You have to feed plants in coir
Coir gives a plant almost nothing to eat. Most bagged potting soil has a starter charge of fertilizer. A homemade coir mix has none unless you add it.
- Start feeding two to four weeks after potting, during spring and summer.
- Use a complete fertilizer at the label rate or weaker.
- Choose one that lists calcium and magnesium, most of all if your coir is not buffered or your tap water is soft.
- Stop or cut back in winter when growth slows.
Best fertilizer for indoor plants explains what to look for.
How to water a coir mix
Coir changes color as it dries. Wet coir is dark brown. Dry coir is light tan. This makes the surface a handy guide, but check deeper too.
- Push a finger 5 cm (2 in) into the mix. Coir can look dry on top while it is still wet below.
- Water when the top 2 to 5 cm (1 to 2 in) is dry for most tropical plants.
- Water until it runs from the drainage hole. This flushes out salts.
- Lift the pot. A coir mix is light when dry and heavy when wet.
A mix that is mostly coir holds a lot of water. In a cold climate in winter, with weak light and cool rooms, it can stay wet for two weeks or more. Use more perlite and bark for plants in low light.
Common problems
- Brown leaf tips soon after potting. Likely salt in unwashed coir. Flush the pot with plenty of water several times, or repot into rinsed coir.
- Pale new leaves or weak growth. The plant is hungry. Start a regular feeding routine.
- Soil stays wet and the plant droops. Too much coir and not enough air. Repot with more perlite and bark.
- Mix dries too fast. Too many chips or perlite for that plant. Add more fine coir.
- Fungus gnats. Coir does not come with gnats when stored dry, but any moist mix can host them. Let the top dry between waterings.
Quick checklist
- Buy washed, buffered coir when you can.
- Soak in warm water, then fluff.
- Rinse unwashed coir two or three times.
- Never use coir alone. Add perlite, bark, or pumice.
- Feed with a complete fertilizer that includes calcium and magnesium.
- Check moisture below the surface before you water.